Amador

🛠️🛠️ Demand service No cool Upon arrival, client inform me that her system was making a growling noise Client set thermostat to cool, condenser fan motor kicked on compressor growled multiple times trying to start With further investigation, it was discovered that start kit and capacitor. We’re both completely out of range. While testing equipment, it was also discovered that contactor was very pitted due to multiple attempts to start Spoke with client Recommend system rejuvenation Client approved recommended repairs 🛠️ Replaced condenser fan motor Capacitor, start kit and contactor Cycle equipment Rinse condenser coil ✅ System is now operating properly and within limit limits

🛠️🛠️ Demand service S#25172MWFJG POV system LR Upon arrival, inform me of a rumbling noise coming from return vent Went up to the attic for further investigation. It was undiscovered a piece of liner, causing noise issue. Remove liner set system on test mode Checked equipment settings at circuitboard ✅ Equipment is operating properly and within limits No more rumbling noise

🛠️🛠️ Unit SN ****E20751 Master bedroom Replacing OEM communicating board and inverter drive Carrier communicating system Before repairs check for any electrical shortages that may cost inverter drive to short out Check compressor verified plug, and windings weren’t grounding Installed circuit boards program and properly commission to equipment Cycle system on cool and verified system operation Check fan motor, compressor, amps, and refrigerant pressures. ✅ System is now cooling properly and within limits

🛠️🛠️ Demand service No cool Upon arrival, client inform me that system was not cooling Thermostat was taped up to the wall With further investigation, it was discovered that thermostat was not properly seated on back plate Mobile home, wood panel, when attempting to put thermostat on the wall, the panel sink in Client just moved into property Spoke with client and recommend performing first maintenance this way I can get an overview of all of the equipment While performing maintenance found compressor was pulling high amps due to a dirty condenser coil Refrigerant and all other components were within range Rinsed equipment and replaced two 16 x 20 filters Also recommend replacing thermostat (thermostat conflict back plate) After maintenance and thermostat install installation ✅ System is now operating properly and within limits

🛠️🛠️ Revised System Operations – Previous Repair * Opened evaporator coil and verified TXV metering device. * Replaced restricted filter-drier * Re-glued condensation line couplers; found and repaired minor leaks. * ⚠️ System took longer than normal to pump down, raising concern about compressor operation. * Pulled vacuum, pressure-tested filter-drier fittings, and reintroduced refrigerant. * Compressor overheated during startup. Cooled compressor and washed dirty condenser coils. * System restarted and stabilized at 63°F vapor saturation / 179 PSIG suction / 10A compressor amps. * ✅ Achieved a 20° temperature split at the furnace. 🗣️ Client Communication * Explained that the system is currently operating and cooling as expected mechanically. * ⚠️ Advised that high suction pressure and vapor saturation temperature remain abnormal. * Also explained that the extended pump-down time may indicate the compressor is not operating at full capacity. Previous tech pointed out some iss

🛠️🛠️ Demand service No cool Upon arrival thermostat was set to cool, blower motor kicked on Went to outdoor condenser and found that system was not working After further investigation, it was discovered system had a weak capacitor Called client informed her of findings Client approved Only charge for labor I was here about two weeks ago. Revised previous repair and verified that everything is operating as it should Check refrigerant AS A COURTESY Rinsed condenser coil very dirty ✅ System is operating properly and within limits

⚒️⚒️ DEMAND SERVICE – NO COOL 🔧 Customer Concern: Follow-up visit for system still not cooling after the evaporator coil was replaced earlier in the day. 🔍 Diagnostics: • Checked refrigerant pressures — pressures were excessively high. • Rinsed condenser coil and monitored pressures — pressures remained high. • Inspected evaporator coil, filters, and return ductwork, including attic air intake — no airflow issues found. • Further inspection revealed the evaporator coil had no TXV metering device installed; no piston/filter assembly was present. 🛠️ Repair: • Pumped down the system. • Separated refrigerant tubing and confirmed missing metering device. • Installed TXV and restored system operation. ✅ Final Results: System is now operating properly and within manufacturer operating limits.

🛠️🛠️ Demand service Upon arrival Client asked to relight his water heater ✅ re-lit water heater ✅ checked refrigerant 1.5 ✅ ductless temperature System is operating properly and within limits Water heater is also heating water

❄️🧊 Preformed a semi annual cooling service on split heat POV Replace 20 x 30 filter/ceiling mounted Condenser located on ground Cycle equipment follow cooling sequence of operation check refrigerant, and pressures Thermostat checked out OK Check fan motor and compressor amps Cleared condensation line from outside Rinsed condenser coil ✅ Cooling equipment, checked out operational at this visit.

🛠️🛠️ Returned to check system Opened evaporator coil preformed electronic leak detector, Visual leak detector and tested unions with blue Nothing was found no oil on condensation pan Went to condenser Removed condenser top, perform an electronic leak search, visual inspection search and tested unions with blue Nothing was found Pumped down system Pressurize, refrigerant lines, and evaporator coil with nitrogen a add pressure sensors on suction and liquid lines Will return in three days to inspect gauges for pressure loss Called homeowner informed him of today’s tasks Will follow up with client on Friday to get access to property

Received only communicating board Need inverter board Client is paying for over night delivery Attached is a new estimate please sign and accept We are holding a spot for Wednesday afternoon If part does not arrive to manufacturer within working hours, we are also holding a spot for Thursday morning

⚒️⚒️ Demand service No Cool Upon a rebel, Client informed me that system was taking a long time to reach desired temperature Thermostat was calling for cooling displaying indoor temperature at 82° Went to auto equipment for further investigation check all moving components and then found that system was 2 pounds low on refrigerant Spoke with Client , Client approved balancing refrigerant ✅ System is now operating properly and within limits

🛠️🛠️ Demand service No cool Upon arrival, client directed me to Casita , thermostat was set for 75° Indoor temperature 90+ degrees Indoor blower was working, but only blowing room temperature out of the vents Went to outdoor equipment where it was discovered that system had tripped a breaker due to bad capacitor and start kit Installed components to test equipment, re-energize unit and system started working Spoke with client-client approved necessary repairs ✅ System is now operating properly and within limit As a courtesy replace 18 x 18 filter See Notes

❄️🧊 Performed a semi annual cooling service On two units Replace filters throughout the house nest thermostat check out OK Cycle equipment follow cooling sequence of operation check refrigerant, and pressures Checked capacitor, fan motor, compressor, amps and voltage Cleared condensation lines Rinsed condenser coils Renewed membership Booked winter maintenance ✅ Equipment checked out operation operational, and within limit limits

🛠️🛠️ Demand service No cool No cool Upon arrival, property manager directed me to thermostat / blank thermostat Went up to the equipment for further investigation It was then discovered ❌ blown low voltage fuse ❌ shorted, contactor ❌ shorted thermostat 📞 Spoke with homeowner over the phone informed him of the findings Client approved recommended repairs ✅ replaced low voltage fuel ✅ replaced contactor ✅ replaced thermostat After repairs were made cycled equipment and verified system operations and temperature split ✅ Equipment is now operating properly and within the limit

On arrival system was working properly Set thermostat on and off everything was working If fan stays on again client will call the office

🛠️🛠️ Demand service no cool Unit system # N436-A Bedroom system Upon arrival, client inform me that bedroom system was making a noise that was coming from the attic, also the previous day technician added 4 pounds of refrigerant and again today system is not maintaining temperature Set thermostat to cool went to upper equipment and found system out of refrigerant Went out to the attic for further investigation and found a leak on coil SpokeWith client on finding and the next steps to getting issue resolved Will order coil from carrier and follow up with client on ETA

🛠️🛠️ Unit SN ***** 2205 Upon arrival, client informed me the back bedroom was not cooling Thermostat was set to cool but only blowing room temperature out of the vent Went to outdoor equipment, found system, not engaging due to pressure switch After revising pressures, it was done determined the system was flat on refrigerant Courtesy Went up to the attic identified system, and was able to find leak in evaporated coil Presented client with repair options, but recommend replacing equipment due to age of equipment and reliability Client approved system replacement office. Will follow up with client for installation.

Reset and re-programmed Honeywell thermostats for dining, lobby and tennis areas Educated on thermostat settings partially looked

🛠️🛠️ Demand service No cool Air handler SN****MLMJG Living room system Upon arrival, client directed me to the living room unit, thermostat was blank Went up to the attic for further investigation and found loose fuse bracket Time all low-voltage connections and high voltage connections Reset equipment and verified system operation Bedroom thermostat set for 75 and reading 80° Went to condenser and check in charge on both units ✅ Both unit units are operating properly and within limit limits 🗣️ Client communication: Informed client that return was taking air from living room area, causing temperature to rise at bedroom thermostat However, after I was done, diagnosing equipment bedroom temperature had already started to drop

🛠️🛠️ Demand service Thermostat issue Upon arrival, client inform me that thermostat was acting funny Reset thermostat and verified system operations Thermostat has a screen screensaver, screen goes dark and indoor temperature bounces around the screen that’s normal Educated neighbor on how thermostat works System is operating properly and within limits Client paid Trip charge Warranty pays diagnostic

🛠️🛠️ Noise issue Upon arrival client informed me that system makes a noise at night when it’s quiet ( system operates at lower speed) Replaced customers supply filters Went up to the attic for further investigation, shook air handler Move air handler away from trusses check airflow, checked for manual dampers. Also make sure that refrigerant lines weren’t touching evaporator cover. System was set on test mode System is operating smooth and quiet at this time Ask client to move register lever when he hears that noise. It might be a register issue. ✅ System is operating properly and within limits

🛠️🛠️ Noise issues 2026 gold system Informed client the way gold system works, variable speed on compressor and blower motor, system operation is normal. Compressor is ramping up and down as it should. ✅ System is operating properly and within manufacture specifications

❄️🧊 Two Lennox split systems 2018 and 2020 / 4 ton Cleared condensation lines, tested water, safety switches and replaced 16 x 25 filters located within the furnace/garage up-flows Cycle equipment followed, cooling sequence of operations Checked capacitor, fan motor, compressor, amps, and a voltage Secured and clean electrical connections at condenser and fuse box Check refrigerator pressures Thermostats checked out OK Rinsed both condensers ✅ Cooling equipment checked out operational at this visit

🛠️🛠️ Demand service Noise issue Upon arrival, client informed me that one air conditioner kicks on there’s a noise that comes from the attic Dropped thermostat 5° to engage second stage cooling After blower motor ramps up a thump came from the attic Went to the attic/air handler for further diagnosing Removed filter from register cycle system on and off multiple times It was determined that filter was so restricted it was causing Platinum box to suck in After filter was replaced noise went away ✅ System is now operating properly and within limits