Daniel

Installed 4 Ton 14 SEER Silver 14 Ultra Low Nox Upflow Split System. Duct board the closet, new transition from duct to coil, flushed with r11 and nitrogen, pressure to 300 psi, replaced disconnect, fuses and breaker to all match unit of 35 amps, vacuumed to under 500 microns. Tested and charged system with R454B refrigerant. Customer paid by check.

Installed 2 ton 18 SEER. Job complete. Customer paid by check.

Installed 2 Ton ductless 20 seer, ran our own electrical and replaced 2 dampers in a tight working area.

0 percent Financing for 18 months free ductless for fall promotion. We replaced the complete system, tested and charged with refrigerant. I changed the filter 20x30, made sure all areas were cleaned and sent Angelo pictures of the attic access.

Replace 5 Ton Evaporator Coil in the attic. Disassemble evaporator coil, remove ducting attached and remote return box in order to remove old unit. Replaced evaporator coil and tested and charged system. It was a very tight attic and took us all day to remove and install the new one.

Installed new 3 Ton Silver 14 Ultra Low Nox Upflow Split System. Job complete, however we need the electricians to replace the breaker because I did not have a 30 amp Zenzco breaker.

I made 10 hardwire whips

The technician assessed the feasibility of the job and estimated that a full day will be required to replace the coil. Due to space constraints, the return plenum may need to be removed, and it is possible that the entire system will have to be disassembled for the coil replacement.

The evaporator coil replacement was successfully completed, followed by charging the system with refrigerant to secure optimal performance. The job has been finalized satisfactorily.

The installation of a 5-ton American Standard Gold 17 gas heating horizontal system was completed, along with the replacement of an 18-inch return duct. Additionally, a Honeywell S200 WiFi thermostat was installed to provide advanced temperature control and connectivity features.

Installed a 5 Ton American Standard Gold 17 Upflow Split Heat Pump System. The installation process included flushing the system with R11 and achieving a pressure of 300 psi. A thorough vacuum was performed, reaching levels under 500 microns, followed by testing and charging the system with R454B refrigerant. The technician conducted a detailed overview of the installation with the customer, demonstrating how to operate the thermostat effectively. Additionally, Johnathan will return later to discuss financing documents and provide the warranty book to the customer.

I made 10 La Quinta hardwire whips

Will need electrical department to run electrical from breaker panel through attic to other side of home. Air handler above side door. Outdoor unit too right side of side entry door in rocks on pad.

The evaporator coil was replaced under the full warranty coverage. The system underwent pressure testing, confirming integrity at 300 psi. A thorough vacuum process was completed, achieving a level of 500 microns, followed by the charging of the system with R410A refrigerant, bringing it to the factory-specified charge level.

The following work was completed: A 5-ton Gold 17 horizontal system was installed. The Lineset was flushed with R11 and nitrogen, and then pressurized to 300 psi to ensure there were no leaks. The system was vacuumed to below 500 microns, after which it was tested and charged with R454B refrigerant. Additionally, a hardwire whip was installed in accordance with code requirements. A new condensate drain pan and a condensate safety switch were also installed. We also replaced both filters. After the completion of the installation, the work area was cleaned, and the customer was guided through the completed tasks. Both zones of the system were confirmed to be functioning properly, and the customer was made aware of the necessary attic access repair, which was communicated to Angelo.

The installation of a 5 Ton American Standard Gold 17 horizontal split heat pump system was successfully completed. The installer flushed the lineset using R11 and pressurized it to 300 psi. A thorough vacuuming of the system was performed, achieving a vacuum level under 500 microns. The installer then tested the system, charged it with refrigerant, and confirmed the operation of all three zones. Additionally, the installer moved the Amazon package inside and set all three thermostats to 86°. The key was returned to its original location under the table on the back patio.

Installing 5 Ton American Standard Gold 17 horizontal Split Heat Pump System.

I made 10 hardwire whips

Installed two 4 Ton American Standard Gold 17 Upflow Split Heat Pump Systems. This installation included the addition of new plenum transitions for both systems. The refrigerant lines were thoroughly flushed using R11 and nitrogen, followed by pressurization. Both systems were vacuumed to below 500 microns to ensure optimal operation. Comprehensive testing and charging of the systems were completed to verify performance.

I made seven hardwire whips

The invoice includes the installation of two 4-ton American Standard Platinum 18 POV split heat pumps—one horizontal and one upflow. The work involved flushing the refrigerant lines with R11, pressurizing the lines, and performing a vacuum down to 500 microns to ensure optimal system performance. Additionally, new low-voltage wiring was installed for both systems to facilitate efficient operation.

Estimate to install a 1.5 ton American Standard Silver 14 split heat pump.

The following work has been completed: Three HVAC systems were installed, including two Platinum systems with capacities of 4 and 5 tons, and one Silver system with a capacity of 3 tons. All three systems underwent a thorough flushing process. Additionally, two plenums were replaced, and hardwire switches were added to each system. Assistance was provided to Chris in running new low voltage wiring for all three systems.

We checked the water heater and everything is fine it was the timer that turned off the circulating pump

Installing 4 & 5 ton Horizontal American Standard Platinum 18 split gas systems.