Service Area

Installed condenser fan motor for bedroom system S-7YJF and tested

Performed annual cooling maintenance on 2) Lennox split systems and a casita Lennox heat pump. FAUs are located in hallway attic access. Replaced 20x30 and 3) 14x24 filters located in ceilings. Cleared condensation lines from faus. Followed sequence of operations and checked voltage, condenser fan motor amps, compressor start/run amps, capacitors, hard start kit, temperature split, Freon levels, and rinsed condenser coils. Secured all electrical connections. Casita unit S#8383 has a capacitor reading below tolerance. Informed and recommended replacing capacitor to prevent any breakdowns. Client requested estimate, sent estimate via email. Thermostats checked out operational. Systems are working properly in cooling at this time of service.

Arrived at customers home could hear the fan vibrating from underneath the attic access. Found motor was good not hot not overloaded fan blades not wobbly. Installed vibration, dampening pads, i.e. earplugs to fan should as a dampening measure. fans no longer making noise only smooth blade sound now.

Performed annual maintenance on two 2024 American Standard Platinum Series systems. * Replaced one 25×30 air filter and one 16×30 air filter. * Both 1050 thermostats were checked and tested for proper cooling operation. System 1 (Bedroom): * Upon arrival, the 1050 thermostat displayed active system alerts indicating offline/missing sensors and unassigned sensors. * Verified no remote sensors are installed. Cleared the sensor configuration and removed the inactive sensor assignments. * Cleared all active system alerts. Thermostat is now operating properly with no active alerts. System 2: * Verified thermostat operation. No operational issues found after inspection. * Cleared any stored system alerts. Performed the following maintenance on both systems: * Verified refrigerant (Freon) charge. * Checked compressor amperage. * Inspected blower motor operation. * Inspected condenser and electrical components. * Verified condensate drain operation. * Checked overall system performance in cool

Call MICHEAL before going twice no answer,,,,,show up to home no answer

2019 Lennox model check capacitor start kit compressor and fan motor amps refrigerant level everything is working within specifications,,,,,

Completed a cooling maintenance on a split system. Washed outdoor unit, cleared condensate and replaced filters. Performed refrigerant circuit diagnostic, check capacitor and electric motors. Disconnect/thermostat: good. Client renewed club membership – paid via C. C. System is cooling the home at the time of maintenance.

Performed a cooling maintenance on a gas package. Checked running/starting capacitors, refrigerant circuit diagnostic and electric motors. Disconnect/thermostat: good. Washed outdoor unit and replaced filter. System is cooling the home at the time of maintenance.

After Diagnostic coil was iced up defrosted coil put gauges on found system was low on Freon added 3 pounds of 410. And changed filter recommend replacement due to age of system sent estimate for leak check also signed up client on comfort plan

Upon arrival, member stated the zoning system was displaying fault codes and not operating properly. Reviewed thermostat alerts indicating two wireless sensor communication loss faults (TSO.001.00) and one indoor temperature sensor fault (SOP.004.00). Based on the displayed fault codes, inspected the wireless remote room sensors and found both sensors had depleted batteries. Replaced batteries in both wireless sensors, restoring communication with the zoning system. Verified fault codes cleared and confirmed all zones resumed normal operation. Informed member of findings and explained that depleted batteries in the wireless room sensors caused the communication loss and related zoning faults. System is operating properly at this time service was covered under warranty