Indio, CA

Upon arrival client stated hot guest room. Found room is furthest duct run. Recommend duct modifications with new return.

🛠️🛠️ Demand service Upon arrival, client informed me that one of her smoke detectors had beeping Healthcare provider removed smoke detector and beeping went away They reinstalled it and beeping came back On arrival I didn’t hear any smoke detectors chirping Client directed me to the bad smoke detector I also assessed other smoke detectors that didn’t have a green light indicator Removed smoke detectors that weren’t working total of 2 ( home has smoke detectors where need these were installed at some point surface mounted smoke detectors) And replaced the one client told me was back Gave client option to replace all of them at the same time But only decided to replace one Thermostat Programmed all three thermostats to automatic heating and cooling setting And set them on a hold Educated client on how to adjust temperatures ✅ Heaters are working at this time

Upon arrival blower was constantly running after diagnostic found triggered high limit switch reset switch units cooling property at this time

After Diagnostic found fuse was not making proper connection at circuit board pushed in fuse unit is up cooling

Completed heating maintenance on two American Standard Platinum heat pump systems located in the attic access. Performed a thorough inspection of both systems, checked all electrical components, verified proper heating operation, and inspected overall equipment condition. Checked temperature performance and made sure all components were operating within manufacturer specifications. Cleaned out both condensation lines to ensure proper drainage and prevent potential blockages. Also verified thermostat operation and made sure both systems switched back into cooling mode properly after maintenance. At this time, both systems are operating properly with no issues observed.

Indoor unit safety inspection and maintenance. On both units, checked refrigerant circuit diagnostic. Checked static pressure measurements and blower motor amp draw. For casita, checked capacitors and running/starting amperage on all motors. Replaced filters and cleared condensate drain. Both systems are functioning according to manufacture specifications.

Completed a heating maintenance on one heat pump system located in the attic. Performed a thorough inspection of the system, checked all electrical components, verified proper heating operation, and inspected the overall condition of the equipment. Checked temperature performance, cleaned out the condensation line, and made sure all components were operating properly and within manufacturer specifications. Also inspected two mini-split systems and verified that both are operating properly in both heating and cooling modes at this time. After completing maintenance, confirmed all systems are operating as intended and left the equipment running properly with no issues observed.

🔥💨 Single system maintenance 2022 Lennox split system 90% furnace located in attic/master closet access Condenser located on ground Semi annual HVAC fall service Cycle equipment followed heating sequence of operation Checked into fan motor, blower motor, heating safety sensors, gas, pressure, flame sensor, amps and voltage Cleared condensation lines Left filter replacement two 14x24 and 20x30 located on lower wall Cleaned out burners, furnace, and mechanical platform Blower wheel checked out operation Thermostat checked out OK Check for carbon monoxide throughout the house/nothing detect ✅ System checked out operational and within limits 📆 Schedule summer visit

Performed annual heating maintenance on a 2014 Trane split system. Client replaced 20x30 and 14x20 filters prior to arrival. Left behind filters. Replaced 10x10 filter in attic. Attic access for fau is located in master closet. Cleared condensation line from fau. Cleaned out burners furnace. Verified heating sequence of operation is working properly according to manufacturer specifications. Checked and detected zero carbon monoxide. Checked temperature rise. Checked capacitor for blower motor. Everything checked out within range. Honeywell 6000 thermostat checked out operational. System is working properly in heating at this time of service. Prebooked cooling maintenance on site with client.

Heating service on Maytag split system. Cleared condensation line and cleaned 20 x 25 x 5 filter located within the furnace/garage flow. Cycle equipment followed sequence of operation check into order, blower motor, capacitor, heating safety sensors, amps and voltage. Thermostat checked out OK. Cleaned out burners, furnace and platform. Heating equipment checked out operational at this time.