Desert Hot Springs, CA

Today’s calling maintenance consisted of one system in the backyard. I first began with replacing filters for the home. Thermostat is properly calling for cooling. Systems pressures are checking out good. Capacitor is also testing out good. Condensation line is draining properly. And the blower motor is checking out in the correct range. I also ensure that the delta T is also providing the correct temperature. All of the cooling sequence of operations are successfully checking out, ensuring that the home is calling efficiently to the desire temperature. thoroughly washed coils down of system to remove during debris. Overall system is operating to manufacture specs at this time, of today’s cooling preventative maintenance. Booked client for Jan 6th

Upon arrival blower working condenser wasn’t after further inspection found condenser fan motor seized up replaced motor in tested

This estimate is only good for 30 days from service date Spoke with client on other efficient systems Also spoke with client on heat pump and JB extended labor warranty Will credit today’s repairs towards new system if estimate accepted with the 30 days of service

Today annual cooling preventative maintenance consisted of two units located on the side of the home. I first begin with replacing all three filters throughout the home, including the Casita as well. All of the cooling sequence of operations are successfully checking out for both of the systems, ensuring that there is a proper 20° split between each liquid line and suction line to ensure that the home is calling efficiently to the desire temperature. I also ensure that both of the condensation lines are draining properly with no obstructions to the lines. Both of these systems are testing out in the correct range ensuring there’s a controlled voltage being used safely throughout the blower fans. And the 4 ton unit had bad testing capacitor out of range. I did inform the client he gave the OK to go ahead and replace these items to prevent any future issues. After replacing the system, both units are testing normally for the capacitors. And both of the coils on these units are free of de

Client dose t qualify for financial

The following is a revised invoice summary based on the provided data: **Installation Overview:** - A 1.5-ton ductless system is to be installed for the garage as per customer specifications. **Scope of Work:** - The indoor unit will be mounted on the rear wall of the room situated above the garage. - The condensing unit is to be installed on the rear garage wall, positioned a few feet above ground level. - A lineset will be run down the exterior wall leading to the condensing unit; a wall bracket will be required to support this installation. - The existing wooden deck will need to be notched for proper fitting, and a plastic cover will be utilized for protection. - Electrical power for the condensing unit will be managed by the client's hired electricians, who will coordinate on-site. **Materials Required:** - A 15-foot lineset cover is required for the proper concealment and insulation of the lineset. This summary reflects the intended work and materials required for the install

advice client we don’t work on portable ac

Phone call Client was asking about difference in pricing between us an general Also permit And quality of equipment

🛠️🛠️ On arrival, client informed me that when system shuts down, it has a swooshing noise Installed an active 24 V two reversing valve and condenser circuit board Rewired system from attic and condenser Explain to client the smooching noise System is now operating properly and within limits

Returned to replace 20x25 filter that was missed during maintenance visit. Updated filter notes home has 9 total 20x25 filters and not 8. Upon arrival client stated master bedroom unit not coming on. Thermostat set to OFF, cycled to COOL and unit kicked on. Verified proper voltage and amperage’s. Found unit over charged with refrigerant. Subcooling at 23°. Recovered refrigerant and subcooling now at 12°. Unit possibly overheated due to being overcharged.Temp split at 21°. Thermostat has dropped 5° before leaving. Unit is cooling at this time of service.