Desert Hot Springs, CA

Partial install no cool. Upon arrival, client told me system was installed on Thursday but stopped cooling properly. I had client turn system on and compressor and blower motor would operate condenser fan motor would not. With further inspection I discovered high voltage line wire burnt and melted not making good contact in lug nut. Repaired wire and test system. System is now operating and cooling properly.

The existing invoice specifies the installation of a 5-ton American Standard Silver 14 heat pump condenser. Job complete

🛠️🛠️ On arrival, client informed me that system wasn’t keeping up around 2 PM then catches up at night Package unit, on the ground micro channel coil Open blower compartment and found icing up on evaporator coil Spoke with client informed him of findings client approved recommended repairs Added 2 pounds of R410A Courtesy, rinsed, condenser, and replaced filter ✅ System is now cooling properly and within limits

🛠️🛠️ On arrival, client informed me the system stopped cooling for them the night before Set thermostat to cool indoor equipment kicked on Went to requirement and found that condenser had no power to it After checking all electrical components, it was in determined Fan capacitor, compressor, capacitor and high voltage fuse were out of range/ bad Installed test components and verified system operations Compressor Max 18 currently at 16 Informed client compressor is just hanging in there as soon as temperatures rise. The amps on the equipment will also rise. Attached is an estimate for full system replacement Spoke with client on another equipment. Client was only interested in Single stage equipment ✅ System is cooling at this time 🚨 Compressor amps on red

The existing furnace was measured at 19.5 inches by 74.5 inches, and the installation involved a complete 4-ton system. A Honeywell S200 thermostat was also installed as part of this service.

Continuation from previous visit On arrival found system low on refrigerant again Remove condenser top, pressurized system, and found leak at coil Spoke with client on repair options also gave them the option to replace equipment Will be installing condenser on Thursday 🗣️🗣️ Spoke with client and let him know that although I found leak at condenser, there could be a small possibility that system may have a leak elsewhere System was not isolated which allows us to test each component individually

Will get with management team. Client wants to quote for a mini split that has multiple heads.

Email ductless estimate.

Today’s call consisted of one Goodman system located at the side of the home. I first began at the Honeywell thermostat to ensure that the thermostat is calling for cooling to the system with no errors and there’s no alerts on it. I then check the condensation line and I went ahead and cleared the system after clearing it a few times there was a small amount of drainage occurring. Once I opened the panel, the system already had a hard start kit, and I went ahead and checked the amperage on the blower of the fan and it is testing out safely in the correct range. The fuse is at the disconnect box are also testing out normal in the correct range. Clients also have a protection at the disconnect box and it is still with a green light. The capacitor also successfully tested out for its rated amount ensuring it’s in the correct range. Once gauging up, the system was not providing a normal sub cool / pressures were out of range significantly. It was testing in negative. So after getting thos

Upon arrival, indoor unit operational not outdoor unit. Upon further investigation on a blown run capacitor after replacing run capacitors this is screwed up and started to cool down the house properly compressor amps fan motor amps and refrigeration levels are within range. Highly recommend signing up on maintenance plan to keep system cooling properly. I will call us back at a later time to do maintenance.