Desert Hot Springs, CA

Maintenance for cooling on a Rheem 5 ton 2017 split system. 20 x 30 filter located in hallway attic axis located in hallway as well. Condensation line cleared filter changed. Nest thermostat working properly. Checked system sequence of operation. Checked compressor amps, checked fan motor amps, check disconnect box, check Freon and temperature split. Disconnect box was slightly hanging off the wall had to adjust wall mount. Washed outdoor unit down. System is working per manufacture spec. Home is cooling properly.

Upon arrival water safety switch was engaged. primary was completely backed up. After cleaning out condensation line relocated water safety switch to secondary had to make corrections to primary after doing so as shown in pictures. System is now draining properly. System is up and cooling down. The house was 93° inside House upon arrival before leaving went all the way down to 86.

Performed a cooling maintenance on a Goodman gas package (4-ton). Replaced filter. Disconnect box is hardwired with only access to cut power at service panel. Thermostat – OK. Documented refrigerant circuit diagnostic (delta T). Properly mounted and insulated from electrical shock herm/fan capacitor. Capacitors measured good. Found high running amps for compressor motor 19/18A. Informed client that high running amps on a compressor is a sign of impending failure. Informed client that he can be proactive or reactive. Running amps on fan motor were good. Client enrolled in club membership. Pre-booked heating maintenance. System is cooling the home at the time of maintenance.

Performed a cooling maintenance on a Lennox straight cool condenser. Documented Delta T. Refrigerant circuit diagnostic – good. Checked thermostat and disconnect box. Checked electrical motor readings and dual run capacitor. Replaced filter. System is cooling the home at the time of maintenance. Pre-booked heating maintenance.

Today’s annual cooling preventative maintenance consisted of one carrier unit at first begin with replacing the 20 x 30 and 14 x 14 filter to ensure that proper airflow is able to circulate back to the system of minimal resistance. I then verify that both of the nest thermostats are properly calling for cooling and turning the unit on with no error code occurring on the unit. And then clear the condensation line thoroughly from the side of the home to ensure that it is properly draining at this time of service. All of the cooling sequence of operations are successfully checking out, verifying that the liquid line and the suction line are providing the proper 20° split which ensures that the home is cooling efficiently to the desire temperature. The amps on the blower fan are successfully checking on the correct range verifying there’s a controlled voltage being used. Following with the capacitor also safely testing out for its correct rated range. All of the cooling sequence of operati

Today’s annual calling preventative maintenance consisted of one American standard platinum unit. I first began with ensuring that the 20 x 30 filter has been replaced to verify that proper airflow is able to circulate back to the system at minimal resistance. I ensure that the 1050 thermostat is properly calling for cooling and turning the unit on with no error codes or messages occurring on the system. All of the cooling sequence of operations are successfully checking out on this unit that is located on the side of the home ensuring that there is a proper 20° split cooling the home efficiently to the desired temperature. I cleared the condensation line thoroughly to ensure that proper drainage is occurring. It is located on the opposite side of the house of the unit. The fan amperage is also testing out safely in the correct range ensuring that there’s a control voltage being used, and there is also no errors or messages on the mitigation board at the unit. The surge protection is s

Performed annual cooling maintenance on 4) 2021 American Standard 4ton packages units. Replaced 8) 20x25 filters located in hallways and master bedroom, and family room. Followed sequence of operations and checked voltage, fan motor amps, compressor start/run amps, capacitors, temperature splits, Freon levels, and rinsed condenser coils. Secured all electrical connections. Inspected evaporator and blower wheels for cleanliness. Honeywell 8000 thermostats checked out operational. Thermostats are located in the hallways and master bedroom. All systems are working properly in cooling at this time of service.

service and safety check 2022 York furnace. Verified sequence of operation is working properly. Replaced filter, cleared drain line. Cleaned out electrical compartment. Verified refrigerant and electrical connections are secure.

Performing a coolingmaintenance on a platinum unit. Checked sequence of operations by checking out all electrical and temperature rise. At this time system is coolingthe house properly. Also, made sure system working within range. No errors or alerts are present. Change the filter and cleaned out condensation line.also help client reconnect 1050 thermostat to his tablet

🔧❄️ Demand Service – No Cool 2002. 3 ton down flow air handler Upon arrival, client informed me that the system was not cooling. Thermostat was calling for cooling, but equipment was non-operational. Performed diagnostic inspection of the air handler and found no 24V output coming from the transformer. Further inspected the contactor to verify it was operating within proper range, as failing 40A contactors can commonly damage transformers. Contactor tested within normal operating parameters. Replaced failed OEM transformer and tested full system operation. Equipment started immediately and is now cooling properly and operating within manufacturer specifications. ✅ System cooling properly at this time ✅ Electrical readings within acceptable range ✅ Verified normal system operation 📋 Client declined Comfort Club membership at this time.