Desert Hot Springs, CA

Performed cooling maintenance on 2025 American standard furnace is locate inside home changed out two 20/20x2 filters Checked all electrical components and refrigerant levels checked volts and amps, capacitor was within range, checked sub cool and superheat in line temp and cycled system. Thermostat checks out OK washed condensing coil, System was within manufacturers specifications and cooling and operating properly at this time of service.

Gym has a lockbox on a Honeywell 5000, calling for cooling to 78°, indoor temp 86°. To turn on equipment there’s a dial timer under thermostat, turn it past ten minutes and all equipment came on. Found system low on r420a, added 1 pound and numbers are to specs, now getting a 24° split, was getting 16° before repair. Recommend having a leak search done so we can find the source and depending on location can quote for repair or replacement. BILL JOB. Office see notes about deleting emails. I updated email. Per Rebecca only send our work invoices to vmoffice@hoappm.com

Existing equipment 24 years old and in very poor condition well past life expectancy. Will schedule to install new equipment, collected deposit.

Arrived at customer’s home to diagnose breaker for gate that is loose. Found that breaker was not properly seated onto bussing. Properly seating breaker on bussing and restored power to breaker to confirm proper operation.

Perform a cooling maintenance on an American Standard straight cool condenser. Replaced filters and washed outdoor unit. Checked capacitors, refrigerant circuit diagnostic and electric motors. Disconnect box/thermostat: good. System is cooling the home at the time of maintenance.

Today’s an annual cooling preventative maintenance consisted of one unit located on the side of the home. I first began with ensuring that the filters have been replaced to provide proper airflow back to the system. I’m minimal resistance. I then verify that the thermostat is properly calling for cooling and turning the unit on with no errors occurring on the system. I then verified that the unit is providing a proper 20° split which ensures that the home is calling efficiently to the desired temperature. The amps on the blower is safely checking out in the correct range verifying a controlled voltage is being used following with the capacitor also testing out safely. I then thoroughly wash the coils down of the unit to remove all during debris that may have accumulated. Overall, this unit is operating to the manufacturer specs at this time of today’s annual cooling preventative maintenance.

Upon arrival, cell system calling for cool, but only link blower motor operating. Upon further inspection found system to have a bad capacitor and blown compressor saver kit. Replaced compressor saver kit and install new 35/5 MFD, capacitor and tested equipment. Checked all electrical components and verified refrigerator. Temperature split 19° in cycled. The equipment is well past life expectancy but cooling in operation now at this time. Informed member of findings and signed up for HFCC will be running credit card given that’s on file

Quoted

Performed a cooling maintenance on two 2022 American standard platinum units. Check sequence of operations by checking out all electrical and refrigeration levels at this time. Both systems are coming down the house properly within manufacturer specifications no error, codes or alerts present changed out filters and finish maintenance by cleaning out condensation lines from outdoor drain pipe as well as by washing down both outdoor units

Performed a cooling tuneup on a living room mini split. Checked temperature Delta T. Washed outdoor coil, indoor filters and cleared condensate drain. Recommend installing equipment surge protection – estimate sent via email. Split system is cooling the home at the time of tuneup.