Palm Springs, CA

❄️🔥💨 Two system service Two 2026 American standard split heat/POV Platinum series Air handlers located in separate indoor mechanical closets Condensers are located on ground Semi annual HVAC fall service Cycle equipment follow system, sequence of operation, blower motor, circuit, board settings, condenser fan motor, compressor, fan and voltage. Verified reversing valve operations. Thermostat checked out OK. Cleared condensation lines, tested water, safety switches, and replaced. Two 20 x 25 filters located within the air handler Got system ready for inspection ✅ Equipment checked out operational and within specifications ☕️🎃 Gave clients Starbucks gift card for October maintenance 📆 Booked summer visit 🛠️ Office will contact client for a city inspection visit Also a Hyde’s tech will return to replace both breakers to 50A

🔥💨 Single system service 2001 York rooftop package unit gas electric Left Filter replacement 14 x 25 Semi annual HVAC fall service Cycle equipment followed, heating sequence of operation, tracked, inducer fan motor, blower motor, capacitor, heating safety sensors, amps and voltage Cleared condensation line Inspected evaporator coil and blower wheel Secure and clean electrical connections at equipment ✅ Equipment checked out operational at this visit ☕️🎃 Gave client Starbucks gift card for October maintenance 📆 Booked summer maintenance

Performed scheduled indoor equipment maintenance and heating safety check on 2016 American Standard equipment located in the office room closet, installed in an upflow configuration. Model: AUD1C100A9H51BC. Serial: 16171SMW1G. Equipment is approximately 10 years old. Washed the washable filter located within the indoor equipment cabinet. Cleared electrical components and burner compartment of dust and debris. Inspected electrical connections, blower assembly, and inducer draft motor; checked voltage and amperage. Verified proper heating sequence, burner operation, safety and rollout switches, and static and gas pressures. Verified zero carbon monoxide detected. Return temperature measured 79.2°F and supply temperature measured 125.9°F, producing a 46.7°F temperature rise, within the manufacturer’s specified range of 30–60°F. Cleared the condensate line through its outside termination near the front entrance, next to the outdoor equipment. Verified thermostat operation and cycled equi

Change thermostat and controller under warranty, also added anchor to back plate for proper securing of thermostat

Demand Service – No Cooling Equipment: 2025 American Standard Indoor Equipment Model: POV0B000M40SDAB Serial Number: 251645CFJG Responded to demand service regarding a no-cooling issue. Upon arrival, verified thermostat was calling for cooling; however, equipment was unresponsive. Inspected indoor equipment and found main control circuit board had no illuminated status indicators. Performed electrical diagnostics to determine cause of failure. Verified proper 120VAC supply voltage at electrical outlet and transformer primary connections. Verified transformer was operating properly with 24VAC present at secondary connections. Traced low-voltage wiring from transformer to appropriate Molex connector supplying power to main control circuit board. Verified 24VAC across R and C with connector plugged into board. Despite proper voltage being supplied, control board remained unresponsive. Verified low-voltage fuse was not blown and installed a test fuse to eliminate possible fuse failure

Indoor unit safety inspection and maintenance. Replaced filter and cleared condensate drain line. Checked refrigerant temperature and pressure. Subcool 11°/superheat 6°. Excellent temperature split. System is functioning according to manufacture specifications. Pre-booked summer maintenance– Starbucks.

Marlene Ackerman quoted on American Standard

Performed indoor safety check annual maintenance in heat on a Goodman located out side closet, followed Sequence of operation Changed 20x25 filter checked amps on blower motor capacitor limit switches safety switches working at range cleared burners cycled burners cleared condensation line unit is working to manufacture specification in heat also left Starbucks card behind

Phone call Followed up with Client. Let him know. I will be ordering some parts. as soon as parts come i will return to the property to make repairs for heater

Completed heating maintenance on two gas furnace systems. Checked the sequence of operations in heating mode and inspected all electrical components to ensure proper operation and that everything is within manufacturer specifications. Verified proper temperature rise, cleaned the condensation lines, and changed the air filters. Finished by confirming both systems switched back into cooling mode properly and were operating as expected.

Performed a heating maintenance on two newly installed heat pumps American standard. Checked sequence of operations by checking out all electrical and temperature rise. At this time, both systems are heating up the house properly no errors or alerts present made sure system switch back into cool properly. finish maintenance by changing out filter and by making sure both systems are draining properly.

Diagnostic on 2013 carrier equipment s/n-0377. Compressor and fan motor non operational struggling to start. Start kit and capacitors failed. Installed compressor starting kit, compressor cap, fan motor cap. Compressor and fan motor are operating properly at this time. Checked motor amps are within manufacture specifications.

❄️🔥💨 Semi annual HVAC fall service Cycle this equipment followed system sequence of operation Replaced 20 x 20 filter/ceiling mounted. Check fan motor, compressor, amps and voltage. Verified heating and cooling operation Ecobee thermostat checked out OK/ reset service alert Cleared condensation line inspected evaporator coil and blower wheel ✅ Equipment checked out operational and with the limits 🗣️ Informed client that system is operating properly Also let him know about whole house air purification And whole house surge protection ✅ Client approved, ultra surge protection Electrical department will be reaching out to schedule enhancements ☕️🎃 Gave client Starbucks gift card for October maintenance 📆 Client will call office to schedule summermaintenance

🔥💨 Two 2005 Payne furnaces If they use are located in garage and indoor hallway, mechanical closet Cleared condensation line and replaced 16 x 25 and 20 x 25 filters both located within the furnace Cleared condensation lines Cycled equipment followed, heating sequence of operation check this order, blower motor, capacitor, flames, gas, pressures, amps and voltage Blower wheels checked out OK Thermostat checked out OK Check for carbon monoxide/nothing detected ✅ Equipment checked out operational at this visit ☕️🎃 Gave client a Starbucks gift card for October maintenance 📆 Client will call office to schedule summer maintenance

🔥💨 Single system 2017 American standard rooftop package union Replaced 16 x 30 filter/ceiling mounted. Cycled equipment followed, heating seasons of operation, checked, inducer motor, blower motor, heating safety sensors, gas, pressures, flame sensor, amps and voltage Cleared condensation line. Inspected evaporator coil and blower wheel housing Cleaned out burners and electrical service compartment Thermostat checked out OK Check for carbon monoxide throughout the house/nothing detected ✅ System checked out operational and within specification ☕️🎃 Gave client Starbucks gift card for October maintenance 📆 Client will call and schedule summer maintenance

🔥💨 Single system Rooftop York package unit gas Left filter replacement/20 x 20 Cycle equipment followed system, sequence of operation Check capacitor, fan motor, compressor, amps and voltage. Thermostat checked out ok Cleared condensation line Cycled heater ⚠️⚠️ Heater is currently not working Will have to order gas valve and flame sensor Also need to update sediment trap Will follow up with client on repair ETA 🎃☕️ Gave client Starbucks gift card for October maintenance Dropped off permit 📆 Client has already scheduled summer maintenance

Heating service and safety check on for systems, 2025 and 2026 American Standard for kitchen and living area. 2006 Equipment for master bedroom and Casita. Cleared drain lines-Replaced all filters located at furnace closets-Casita furnace located inside attic inside Casita. Verified blower motors are operational. Capacitors tested good. Verified gas and electrical connections are secure. Verified Heating sequence of operation is operational at this time. Master bedroom and Casita Equipment in very poor condition-Well past life expectancy. verify cooling sequence of operation is operational at this time. Recommend replacement of equipment for bedrooms and Casita.

Performed a heating maintenance on 2020 ac pro furnace. Filter located inside filter rack, furnace located in outdoor closet, changed filter. flushed condensation line through jones valve. Verified sequence of operation in heating and cooling is operating properly. Amperage and voltage for blower motor and fan motor tested good. Verified blower speed is good. Verified gas and electrical connections are secure. 48 degrees temperature rise, equipment within range per manufacturer specifications. Cleaned dust accumulated inside electrical component. System is working within specification in heating at the time of maintenance. Gave client Starbucks card. Equipment does not have surge protection, advised per manufacturer recommendation to install surge protection to prevent damage to electronics-recommend surge protection on equipment. Attached estimate below also emailed

Indoor unit safety inspection and maintenance, with courtesy mini split service. Equipment executed the sequence of operation in heating. Checked capacitors and blower motor amp draw. Measured static pressure and temperature heat rise. Thermostat: OK. Replaced filters. Both furnaces are functioning according to manufacture specifications. Furnaces are installed in a mechanical closet in the backyard, close to straight cool condensers. Starbucks.

Gas package safety inspection and maintenance. Equipment executed the sequence of operation in heating with no carbon monoxide detected in the home. Replace filters and cleaned burner compartment with CO2 tank. Checked dual run capacitor. Measured inducer/blower motor amp draw. Excellent temperature heat rise. System is servicing the home at the time of maintenance. Starbucks.

Resend and revised

Arrived at customer’s home to replace existing t stat wire that went bad between outdoor unit and indoor unit. Piped through exterior wall, piped around wall and penetrated into home above front door. From there we piped across the kitchen and penetrated into attic that indoor unit was connected to. Ran wire through attic using can light openings to get to indoor unit. Landed all connections and tested units to verify proper operation and complete scope of work for today.

Performed a heating maintenance on a gas furnace located in hallway closet. Cleaned out condensation line washed out washable filter check temperature rise and all electrical components such as inducer fan motor and safety switches at this time. System is heating up the house properly with no errors or alerts present. Blower motor is working properly and is cleared from all debris finish maintenance by making sure your system switched back into cool mode properly.

Performed a heating maintenance on a York package unit located on rooftop. Checked all electrical components such as run capacitor, compressor, amps fan motor amps temperature rise. Also checked out disconnect box cleaned off all electrical components at this time. System is heating up the house properly reaching temperatures of 120° and rising finish maintenance by making sure system switched back into cool mode Correctly. Checked starting amps finish maintenance by making sure system is draining properly off of rooftop and by changing out filter no recommendations made at this time.

Gave customer a phone call to discuss address light. Customer stated he’d rather buy the solar powered version of the address light hand have us simply hang it for him. Will send a revised estimate to reflect this work.