Palm Springs, CA

Performed a heating maintenance on heat pump, located in hallway closet check sequence of operations by checking out all electric and temperature rise. Also cleaned out condensation and change out filter. At this time system is heating up the house properly. Also, make sure system is switched back into cool properly. At this time almost within the range and system is cooling and heating the house properly.

Indoor unit safety inspection and maintenance. Equipment executed the sequence of operation in heating with no carbon monoxide detected in the home. Cleared condensate and replaced air filter. Checked static pressure, blower motor amp draw and temperature heat rise. Client renewed club membership – paid via CC. Starbucks.

Performed indoor safety check on a American standard split up flow location hallway closet, followed Sequence of operation rinsed out filter checked amps on blower motor limit switches safety switches working at range cleared burners cycled burners cleared condensation line through jones valve unit is working to manufacture specification in heat, left Starbucks card behind

Performed annual maintenance and operational inspection on the 2005 Carrier 5-ton split system. * Replaced 20” × 25” air filter located in the outdoor closet. * Checked Honeywell thermostat and verified heating and cooling operation/range. * Performed heating-system operational check, including: * Gas valve operation * Safety switches * Ignition/igniter operation * Blower operation * Capacitor * Blower motor amperage * Cycled cooling system and checked: * Compressor amperage * Compressor capacitor * Outdoor condenser operation * Blower operation and amperage * Tested blower capacitor; 10 µF capacitor was reading 0 µF, indicating capacitor failure. * Contacted client and received approval to replace the blower capacitor. * Installed a new blower capacitor and verified system operation. * Cleared the condensate drain line to help ensure proper drainage. * Cycled the system after service and verified proper operation. System is currently operating

Client not home. Left warranty book and replaced filters last visit 9/14/26 two weeks ago. Verified sequence of operation on equipment is working properly. Verified drain lines are draining properly. Equipment has no alerts.

Performed a heating maintenance on a American Standard package unit, washed filter , filter located on hallway ceiling, flushed condensation line, on unit check for amperage and voltage, followed sequence of operation, check for carbon monoxide, check for capacitor, check for temperature split, everything within range also clear out dust accumulated inside electrical component area. System is working within specification in heating at the time of maintenance.

Indoor unit safety inspection and maintenance for two systems. Cleared condensate drain and replaced filters. Checked static pressure, blower motor amp draw and temperature heat rise. Checked refrigerant circuit diagnostic for heat pump system. Both systems are functioning according to manufacture specifications. Locked home and left keys with security guards.

Heating service and safety check on 2023 equipment. verified equipment is working properly according to manufacturer specifications. Replaced filters, cleared drain lines. Verified no active alerts. Refrigerant pressures tested good.

Performed heating maintenance and safety checks on both 2018 American Standard indoor equipment systems. Indoor Equipment #1 * Model: AUD2C100ACV52BA * Serial: 18194KTE1G * Manufacture Date: 05/2018 Indoor Equipment #2 * Model: AUD2C100ACV52BA * Serial: 18194KKN1G * Manufacture Date: 05/2018 Cleared the condensate lines and cycled both systems in cooling to verify proper operation, including testing the water safety switches and checking temperature splits. Cycled both systems into heating and verified proper sequence of heating operation. Inspected and monitored burners, checked inducer/draft motor operation and associated capacitors, inspected electrical connections for loose or compromised wiring, and verified operating voltage and amperage. Both systems completed testing without issues and are operating within manufacturer specifications. Both systems are heating and operating properly at this time of service.

Ordered new custom registers from including the return all from New York-Price will be $200 for labor when installing return-$195 extra for shipping-$1775+add on costs Installed 2 custom flush supply grills and 1 custom flush return grill. Per Joey he said they will Install the exhaust fan grill due to still figuring shower flooring details. We left grill in shower area Per Joey

Performed a heating maintenance on a 2022 American standard platinum unit. Check sequence of operations by checking out all electrical temperature rise. At this time system is heating up the house properly compressor amps fan motor amps and disconnect or all with the range. Make sure to clean out condensation line as well as changed out filter. Finish maintenance by making sure system switch back into cool mode correctly.

Performed maintenance and safety check on Goodman rooftop package unit. Equipment data plate was unable to be read clearly at time of service. Replaced 24 × 24 filter and cleared dust/debris from electrical components. Cycled equipment in heating and verified proper sequence of operation. Monitored burner operation, checked voltage and amperage readings, and tested the 70/5 MFD dual run capacitor, which was within acceptable range. Verified temperature rise and confirmed proper heating performance. Checked for carbon monoxide during operation with 0 PPM detected. Cleared the condensate line and verified thermostat operation. System is currently within manufacturer operating specifications and heating properly at time of service.

Found bad thermostat for office. Replaced and put systems zones back on and tested.

Installed 2 Ton ductless 20 seer, ran our own electrical and replaced 2 dampers in a tight working area.

Comfort indoor service on (2)2022 American standard platinum heat pumps. Air handler located inside garage, condensers on east side of home. Replaced filters, flushed lines and washed coils. Checked all heater and safety components. Blew out electrical compartments. Checked alert history for any past issues. Surge protection working. Systems are properly running.

Performed a safety check today on a platinum American standard unit located on the side of the home. I first begin with replacing the 20 x 25 filter in the hallway closet clear the condensation line via Jones valve to ensure proper drainage is occurring. The American standard thermostat is properly calling for cooling with no alerts. Surge protection checked out. On the unit checked out checked pressure no alerts on the mitigation board. Overall system is operating to manufacture specs at this time of today’s safety. Check maintenance.

Preformed an indoor and outdoor safety maintenance on an American standard platinum furnace, Filters located inside filter rack, fau located outside closet near front door, changed 24x24 filter, flushed condensation line through jones valve, on fau followed sequence of operation, checked for amperage and voltage, checked for blower speed, check for any loose connections, check for temperature rise, check for any error codes or alerts everything within range also cleared dust accumulated inside electrical component. System is working within specification in heating/cooling at the time of maintenance.

Need to fabricate custom fitting for underground hood.

Spoke with the client while I was on my way to the property. Client stated that the other zoning 824 thermostat is blank and sees no reason for me to come out without having two thermostats available. I informed the client that we would need to inspect the system to determine whether the issue is related to a low -voltage problem. Client requested to wait and reschedule for now.

Client currently working with desert air and wanted second opinion. Advised on equipment options. Will follow up next week on Tuesday.

Maintenance on a Rheem 3 ton R 22 2003 upflow split system. FAU located in the closet in front of stairway 16 x 25 filter at FAU. Condensation line cleared filter changed. Thermostat working properly. Check system sequence of operation. Verified all electrical and safety. Checked pressure, switch, checked inducer motor, checked flame sensor and igniter, checked 24 V on gas valve, checked temperature split, checked compressor, amps, checked fan motor amps, checked capacitor, checked disconnect box. Washed outdoor unit down. System is roughly 23 years old containing r22 freon. spoke with client about systems efficiency and condition of equipment. Advise client call office and request an estimate from Barry. System is working at time of maintenance.

Performed a heating maintenance on a gas furnace split system unit located in attic. Check sequence of operations, by checking out all electrical and temperature rise. At this time system is heating up the house properly also cleaned out condensation line and change that filter cleaned off gas burners. Finish maintenance by making sure system switch back into cool mode properly at this time all is within range.

Preformed an indoor and outdoor safety maintenance 2 2018 Trane Split system, Filters located inside fau, fau located outside closet, condenser located on right and left of home, changed 2 16x25 filter, flushed condensation, condenser S#MU3F replaced Capacitor and added a Start kit, on fau followed sequence of operation, checked for amperage and voltage, checked for blower speed, check for any loose connections, check for temperature rise, everything within range also cleared dust accumulated inside electrical component. System is working within specification in heating/cooling at the time of maintenance.

Arrived at customer’s home to install a customer supplied surge protector on main breaker panel, and to cut in an outlet for a water shutoff that customer is going to purchase. Penetrated out of the back of the panel with romex to plug and surge protector location behind panel. Landed all connections and turned breakers on to restore power to circuit and test them. Verified with customer to complete scope of work for today.

Performed a cooling maintenance on a york package unit. Trix sequence of operations by checking out all electrical and refrigeration levels. At this time system is cooling down the house properly. Also, make sure system was heating up the house properly informed Client about the great benefits of Wi-Fi compatible thermostats finish maintenance by making sure system is draining properly and by changing out, customer supplied filter.