Palm Springs, CA

Quote on American Standard horizontal system

Arrived at customer’s home to re run line for landscape lights and run a low voltage jumper between landscape light systems to eliminate one transformer. Upon arrival I found that customer discovered two timer switches that controlled unknown loads. Turned both timer switches on manually and determined that both timer switches controlled each gfci outlet for the landscape lights. Timer switches were out of programming, so I programmed both switches for customer. Also retrofitted two fluorescent strip lights to led using retrofit kits. Confirmed all work with customer to complete scope of work for today.

Client not home. House under construction. Contacted home owner over phone and determined Reme Halo is best application for equipment type of application. Existing equipment and in good condition.

Performed annual heating maintenance on a 2024 Bryant package unit. Replaced 2) 12x20 filters located in upper wall. No ladder needed. Followed sequence of operation and checked inducer fan motor, blower motor amps and voltage, checked resistance across all safety and limit switches. Cleaned out burners furnace. Verified heating sequence of operation is working properly according to manufacturer specifications. Checked and detected zero carbon monoxide. Checked temperature rise. Cycled unit back into cooling and verified proper operation. ACPRO thermostat checked out operational. System is working properly at this time of service. Scheduled cooling maintenance on site with client.

Performed indoor/outdoor safety maintenance check on a 2021 American Standard Platinum heat pump. Replaced 24x24 filter located in filter rack. Upflow fau is located in indoor closet, cleared condensation line from clear out valve. Followed sequence of operations and checked voltage, amperage, temperature rise/split, refrigerant levels, found no error codes on CDA, and courtesy rinsed condenser coils. 1050 thermostat checked out operational. System is working properly at this time of service. Client renewed HFCP paid via CC.

Gave customer a phone call to answer questions about work to be done this Thursday

Performed indoor safety maintenance check in heating on a 2015 American Standard Split System. FAU located in balcony mechanical closet. Replaced 20x25 filter located in FAU. Followed sequence of operation and checked inducer fan motor, blower motor amps and voltage, checked capacitor for inducer fan motor, checked resistance across all safety and limit switches. Cleaned out burners furnace. Checked temperature rise. Verified microamps for flame sensor. Verified heating sequence of operation is working properly according to manufacturer specifications. Detected zero carbon monoxide. Honeywell 8000 thermostat checked out operational. System is working properly in heating at this time of service.

Upon arrival, fountain bedroom unit 7179 calling for cool and contactor engaged, but unit not responding. With further inspection, I discovered system had an overheated compressor due to a faulty, run capacitor measuring zero MFD for condenser fan motor not allowing fan motor to start. Installed new capacitor and cold off compressor system is now operating and cooling properly.

Performed indoor/outdoor safety maintenance check in cooling for a 2026 American Standard Platinum heat pump. Upflow fau is located in the garage. Cleared condensation line from jones valve and tested water safety switch. Replaced 20x25 filter located in filter rack and rinsed washable filters for garage ductless unit. Checked all systems parameters through American standard technician app. Everything checked out in range. Dropped off permit. Replaced 20amp FAU breaker for a 15amp breaker to match max rated amps on fau name plate. System is ready for inspection. 360 thermostat checked out operational. System is working properly in cooling at this time of service. Scheduled heating service on site with client.

Installed new blower motor and test system.System is now operating and cooling properly.

Arrived at customer’s home to diagnose outlets non op since our last troubleshoot attempt. Found that there was not proper power being provided at both gfci outlets. Both outlets served exterior landscape lighting, so I came up with a plan to eliminate one transformer from line, and connect string of lights to other transformer. Will also set a new outlet off of pool panel for landscape lighting. Will also retrofit two fluorescent fixtures to led in customer’s closet. Gave customer a price for all work and it was approved.

Upon arrival, thermostat was calling for cool but system not responding. With further inspection I discovered system had error code E 17 blower motor not communicating with control board. Insured blower motor was receiving proper voltage and it is. Will need to return to replace blower motor under parts warranty only.

Maintenance on an American standard silver series 3 ton upflow heat pump. 20 x 22 filter located at FAU. FAU located in the closet by dining room. Condensation lines cleared filter changed. Thermostat was barely working properly. Check system sequence of operation. Checked compressor amps, checked fan motor amps, checked capacitor, checked compressor saver kit, checked fuses and disconnect box, checked Freon and temperature split. Washed outdoor unit down. Spoke with client and recommend replacing thermostat. Sent estimate. System is working at time of maintenance.

Performed maintenance on 2011 American Standard rooftop package unit. Change 14 x 36 by one filter. Checked amps, volts, capacitor, and start kit also clean electrical /burner compartment. Insured all high and low-voltage wires were tight and secure making proper contact. Checked all safety components and refrigerant levels. System has proper condensation line and drainage. Found all electrical components and refrigerant levels to be within manufacture specifications. System is operating properly at time of service.

Install new Google nest thermostat and client connected thermostat to his phone.

The installation of a 5 Ton 14 SEER Silver 14 Ultra Low Nox Upflow Split System has been successfully completed.

Edited estimate to change outlet from outdoor to indoor

Upon arrival, the Both zoning system werent operating The client has a total of 6 zones. Two thermostats were indicating active 1050 alerts. First 1050 alert: Disabled and re-enabled the zoning system. Verified all 3 zones are up and running. Second 1050 alert: Re-enabled the system, but one sensor remains offline. Checked the batteries and found none installed. Attempted to install batteries, but no wiring or battery connection string was present. Recommendation: Provide a quote/estimate for a replacement sensor. Signed up client for membership will be back to install new 930 sensor and maintenance.

Installed custom lineset cover for 3 zone mini split

Performed a cooling and heating maintenance on package unit AC pro. Unit located on rooftop check sequence of operations by checking out all electrical components, such as run capacitor, compressor, amps, and fan motor amps. At this time, all electrical components are within range. Upon arrival found thermostat had low batteries. Client had batteries right next to thermostat replaced and tested. Thermostat is working properly in both heating and cooling system is also heating and cooling down the house properly as shown in pictures will send estimate via email to clean up and fix thermostat wire that is located on rooftop showing picture. Thermostat wire is in bad shape would recommend repairing before it does become an issue called a client no answer at this time. Left a voicemail. Walked up House after done.

Performed annual maintenance on a 2024 Bosch indoor and outdoor equipment. Replaced the 20" × 25" air filter located in the filter rack in the garage. Checked system operation in both cooling and heating modes. Inspected all levels of operation, compressor amperage, and system alerts. Inspected the evaporator coil and blower motor, ensuring they were free of debris and obstructions. Checked the condensate pump to verify proper operation and drainage. Cycled the heating system and checked blower speeds, blower motor amperage, and electrical components. Washed down the outdoor condenser coils. System Status: The HVAC system is operating properly at the time of service.

No attic access. Did verify there is damper access. Recommend replacing dampers for main home and casita.

Called client to go over estimates. Client to decide between silver and gold

Performed a heating and cooling maintenance on a package unit located on rooftop check sequence of operations by checking out all electrical and refrigeration levels by performing a temperature split was getting a 24° temperature spit, while system was cooling. Was also getting 100° temperature rise while system was heating. At this time all electrical components such as run capacitor, compressor, amps and fan motor amps are well within range. Finish maintenance at this time by washing down package unit changing out filter.

Performed annual maintenance on the 2017 5 ton American Standard indoor and outdoor units. Washed and cleaned the air filter located in the closet filter rack. Checked thermostat operation and verified cooling settings. Cleared the condensate drain line and verified proper drainage. Checked all operational safety switches and verified proper operation of the ignition system. Cycled the cooling system and checked compressor amperage, motor amperage, and capacitor readings. Inspected the electrical components and system operation. Washed down the outdoor condenser coil and removed dust and debris from the equipment. Recommendation: The compressor hard-start kit is reading below manufacturer specifications. Recommend replacing the hard-start kit to improve compressor startup and reduce strain on the compressor. The system is operating properly in both heating and cooling modes at the time of service.