Palm Springs, CA

Upon arrival client stated living room system S-8u4f not cooling. Another tech stated breaker keeps tripping. Removed compressor from circuit and system kicked on. Found grounded compressor. System is 15 years old using r22. Furnace is 2006. Sent over estimates

Called client to go over leak search. Advised I can’t open coil and use leak detector however I don’t believe that is the smell issue. Recommend air scrubbers

Gave customer a phone call to answer questions about panel upgrade.

Replaced filter and lowered fan speed to 350. Noise went away

Arrived at customer’s home to complete panel upgrade. Removed existing panel from home, reworked grounding to bring system up to code, re ran circuit for solar, installed new whole home surge protection. Installed a new 200 amp solar ready square d panel in existing panel’s place and landed all connections. Turned all breakers back on to restore power to home and finish “rough” portion of panel upgrade. Will need to return to label panel, and patch stucco for final inspection.

Upon arrival client stated home has a smell. Client had renters in for a few months. This property is a newer home. Client stated they painted walls and new floors installed. Checked refrigerant levels, levels fine. Client thought possible refrigerant leak smell. Checked and changed dirty filter. Advised client options are indoor air quality products and duct cleaning, referred duct pros for cleaning. Signed up on yearly agreement and will be returning tomorrow to install Reme Halo.

Thank you for your interest in adding air purification to your HVAC system. Because air purification equipment must be properly matched and installed based on the configuration of your existing system, we’re unable to provide an accurate estimate without first evaluating the equipment. The installation location, duct configuration, available space, and accessibility all determine what type of system can be installed and what the installation will require. We would be happy to schedule a visit to determine the best option for your home and provide an accurate estimate.

28/251 28 inches wide 25 inches high 11 inches to the curb which is too small metal frame curb is 24 wide by 34 deep add supply bathroom two 16/8 bar registers

Found slight rattle in blower compartment. Need to have a tech come out and check maybe adjust fan speed? Also bring 25 x 25 filter if we can find one. Bar type return grille

Elizabeth is a real estate agent and one of our customers she is going to send me over some items to bid to repair or replace fuses are the wrong size possibly sediment trap and coat gas lines on roof

Customer is going to sign the proposal for the gold 15 package unit was asking about promotions in November because that’s when they’ll be back in town for the installation. I said I don’t know what they are at this moment but whatever promotions we do have they would be eligible for.

Upon arrival, client stated there was water leaking from the roof top to the first floor. Went upstairs checked package, units. There’s no water visible advised client there’s no way the water would be leaking from the roof to the first floor not going through second floor first It’s not from the air conditioners.

Sent customer email for solar

Arrived to troubleshoot non operational dishwasher and garbage disposal with kitchen island outlets. Additionally troubleshoot two post lights that trip a breaker. I turned switch on and post lights would randomly turn on and off. Opened switch and switch seemed to be working correctly, I move on to the photocell and covered it to ensure it was working correctly. I taped photocell and tested post light switch and it seemed to be working properly. During conversation with customer I noticed that the lights to the post light had gone off again and tripped the breaker every time it was switched on. I returned the photocell and switch to how it was originally installed. During the last of my inspection I noticed a weather rated box with a blank cover in the courtyard garden. I opened the box and discovered multiple wires that were burnt and had water damage. I advised customer of my findings and provided a estimate.

Master bedroom loss of power. Cleared drain line. Unit running on arrival found water in water safety switch. Equipment is working properly at this time

Set thermostat to auto mode

Upstairs lost power due to loose connections. Verified equipment is working properly

Estimate for installing customer supplied whole home surge protector on main breaker panel.

Performed a cooling maintenance on a package heat pump. Washed outdoor unit and replaced filter (no ladder needed). Check the electric motors, capacitors and refrigerant circuit diagnostics. Disconnect/thermostat: good. Pre-booked heating maintenance. System is cooling the home at the time of maintenance.

Upon arrival, member expressed concern regarding condensation being collected in the evaporator safety pan. Verified the condensation was being properly contained and draining through the designated exterior termination. Educated member on the purpose of the evaporator pan and explained that it is designed to catch condensation and direct the water safely to the exterior of the home. Also informed member that if water were to begin overflowing from the pan or leaking into the home, that would indicate an abnormal condition and would require further evaluation. No abnormal condensation or water intrusion was found at this time.

Estimate to install Fittes flush mount registers and exhaust fan. 24x12 return grille approximately $500 but Fittes and Envisivent don't make that size.

Performed cooling maintenance on a 2021 American Standard Gold system. Air handler is located in the outside closet. Replaced the 20 × 25 filter located in the filter rack and cleared the condensate line through the Jones valve, verifying proper drainage. Verified proper sequence of operation, checked system voltage and amperage, inspected capacitors, and checked the rectifier for second-stage cooling. Verified refrigerant performance and obtained temperature splits. Cycled equipment through operation, washed the condensing coil, and verified thermostat operation. At this time, the system is within manufacturer specifications, cooling, and operating properly. Renewed annual comfort plan with member.

Performed a cooling maintenance on two split TRANE units. Cleared condensate drain, washed outdoor unit and replace filters. Installed two float safety switch – paid via CC. Checked capacitors, electric motors and refrigerant circuit diagnostics. Thermostat/disconnect box: good. Both systems are cooling the home at the time of maintenance.

Arrived at customer’s home to move switch box so installers can pull fau out and re set the unit. Upon arrival installers had already shaved framing down to properly accommodate fau into space. Because of this the switch box did not have to be moved for installers to complete their work. Confirmed with installers that they did not need my help before leaving job site.

Performed annual heating maintenance on a 2004 Ruud furnace. Upflow fau is located in outdoor closet in front court yard. Replaced 20x25 filter located in blower compartment. Found water leaking out of coil onto the floor and indoor the blower compartment. Found condensation line clogged. Cleared condensation line and verified proper drainage. Courtesy vacuumed water out of return floor. Water was no longer leaked from coil onto floor nor into blower compartment. Cleaned out burners furnace. Verified heating sequence of operation is working properly according to manufacturer specifications. Checked and detected zero carbon monoxide. Checked capacitor for blower motor. Checked temperature rise. Everything checked out in range. Nest thermostat checked out operational. Cycled cooling after and verified system switched to cool. Client renewed HFCP paid via CC. Heater is working at this time of service.