La Quinta, CA 

After returning living room system was set to 71 reading 75. Well check the condenser system had a three flash code short cycle, compressor is locked out after 10 consecutive short cycling events. Possible issue condenser fan stopped operating. Got system up and running and checked compressor amps and condenser fan amps. Condenser fan amps are rated for one amp and measuring at .98. Explain to client that if system continues to trip, we will need to install new condenser fan motor. Emailed estimate.

Performed annual heating maintenance on 2005 York model furnace. Upon arrival, client reported a very noisy blower motor. Inspected and verified all blower mounting bolts were secure. Discussed with client the option of lowering blower motor speed; advised that reducing speed could pose risks to system operation. Client chose not to proceed with blower speed adjustments due to system age and acceptable operation. Performed full system inspection and followed sequence of operation. Verified proper flame ignition. Checked blower motor operation and speeds. Inspected all safety switches. Tested capacitor and confirmed it remains within rated range. Door switch interruption caused thermostat to reset; thermostat was required to be re-registered to the mobile app. Followed manufacturer procedures and successfully restored app connectivity. Client confirmed mobile app is operational. System is heating properly and operating within normal parameters at the time of service.

Performed annual heating maintenance on two 2013 lennox split systems. Changed out 20x25 and 20x30 air filters. One upflow furnace located in the hallway closet and one horizontal furnace located in the attic closet. Followed the sequence of operations, checking flame ignition, rollout switches, inducer motor, and blower motor. No alerts found on either system; sequence of operations operating properly. Cleared condensation line and tested the condensate pump by draining water to verify proper operation. Both Honeywell thermostats were checked and confirmed operational, maintaining desired temperatures. Performed maintenance on mini-split filters and coils. All systems checked in range and are operating properly at this time of service.

Upon arrival, turned all four systems on to cool and only the Casita unit would operate with further inspection. I discovered master bedroom, living room and guest bedroom systems all needed new dual run capacitors. Installed two new 45/5 MFD capacitors and 140/5 MFD capacitor. Also checked refrigerant levels. All four systems are now operating and cooling properly. Also signed client on annual comfort club.

Performed annual maintenance in heat on a Bryant split gas location hallway attic, followed Sequence of operation Changed filter checked amps voltage blower motor capacitor limit switches safety switches working at range cleared burners cycled burners cleared condensation line unit is working to manufacture specification in heat

Performed a semi annual heating service on split heat system Cleared condensation line and replaced 20 x 25 filter located within the air handler/hallway, mechanical closet Thermostat tricked out Set thermostat to heat but heater did not come on outdoor temperature 85° it was too hot for system to kick on Verified reverse valve operation reversing valve is working And tested equipment on air conditioning Checked blower motor amps and capacitor Make sure connections were secured and tight Check refrigerator through a temperature split System checked out operational at this visit

Upon arrival, client explained history with past company. While preparing to rewire zone board discovered system has burnt resistor. Explain to client we will need to install new zone board and test all three zones. Client signed estimate and signed on comfort club. Zone board has been ordered from Ferguson PO. 24598446–101

Performed a semi annual heating service On split heat system Cleared condensation line Replaced 20 x 25 filter located within the air handler/hallway, mechanical closet Thermostat checked out OK Check blower motor amps Also verified proper voltage Blower wheel has build up Evaporator coil a little dirty Reversing valve and temperature split checked out OK System checked out operational at this visit

Pull Blower Section and Clean Blower Wheel and Housing. Reinstall and Test Operation

Performed a cooling maintenance on a Lennox split system unit. Check sequence of operations by checking out all electrical and refrigeration levels at this time. System is pulling down the house properly reaching designated temperature on thermostat finish maintenance by changing out filter cleaning out condensation line. Also still renew client member

Performed a semi annual heating service on split heat system Cleared condensation line Replaced 20 x 20 filter located within the air handler/hallway, mechanical closet Thermostat checked out OK. Inspected blower motor, blower, wheels, amps, and voltage Checked refrigerant/temperature split High voltage and low voltage water properly secured From previous recommendations Recommend pulling and cleaning evaporator coil for better equipment, efficiency System checked out operational at this visit

Performed annual heating maintenance on a 2022 Amana split system. Replaced 20x30 and 14x14 filter located in lower walls. Fau located in master closet attic access. Cleaned out burners furnace. Verified heating sequence of operation is working properly according to manufacturer specifications. Checked and detected zero carbon monoxide. Checked temperature rise. Cleared condensation lines. Everything checked out in range. Honeywell thermostat checked out operational. System is working properly in heating at this time of service.

Dropped off warranty book and collected signatures

The service involved the installation of a 1-ton, 18 SEER AS ductless mini-split system specifically for the casita. Our team's work ensured comprehensive installation techniques were applied to enhance the system's efficiency and performance. Each aspect of the installation was conducted with precision to meet the highest standards of quality and functionality.

2019 Trample split heat Cycled equipment followed heating sequence of operation Check blower motor, blower motor wheel Cleared condensation line Thermostat checked out OK Checked capacitor Refrigerant/temperature split Secured and clean electrical connections at air handler Verified system amps and voltage. Replace 18x25 filter located within the air handler/hallway, mechanical closet System check out operational at this visit.