La Quinta, CA – AC Repair and Electrician Service

Performed cooling/Heating maintenance on a 2022 Goodman condenser located on the left side of the home. The air filter is located in the hallway ceiling, and the furnace (FAU) is located in the laundry room in an upflow. Checked thermostat operation and verified proper system response in cooling mode. Flushed the condensate drain line to ensure proper drainage and prevent potential clogs. At the condenser, inspected and verified voltage and amperage readings, including compressor and fan motor operation. Measured compressor startup amperage and recommended installation of a hard start kit to reduce inrush current and improve startup efficiency; start kit was approved and installed successfully. Checked refrigerant levels and added 1 pound of refrigerant to bring the system within manufacturer-recommended range. Verified system pressures and overall cooling performance after adjustment. Tested dual run capacitor and confirmed it is operating within rated microfarad range. Inspected disc

Performed a cooling maintenance on a 2022 American Standard Platinum series condenser, condenser located on left side of home, filter located hallway bottom wall, fau located in attic, changed 20x30 14x14 10x10 filter, flushed condensation line, on condenser check for amperage and voltage, check for compressor, check for freon level, check if thermostat had no error codes or alerts, everything within range, clear out dust accumulated inside electrical component area and rinsed condenser coil. System is working within specification in cooling at the time of maintenance.

Ecobee tstats-3ton bdrm system first, 4 ton living system

Arrived at customer’s home to change out sizzling breakers for hvac install today. Replaced 30/15 quad with a 40/15 quad and a 50/15 quad with a new 50/15 quad. Noticed bussing burning up inside main breaker panel. Informed customer of this and offered to give a price for a panel change, but he said he’d get his church friend to fix it.

Upon arrival, client stated mini split located in Casita would make a noise when turning on and off. Turn system on and listen for noise. Noise seem to be coming from motorized louvers. Manually adjusted louvers and I could no longer hear the noise. Client is going to keep an eye on the system to see if he hears it again.

Job complete.

Quote to install a 5 ton American Standard silver 14 upflow gas heat pump.

Coming to the office leaving a deposit

Performed a cooling maintenance on two platinum heat pump, one straight cool Lennox with garage mini split service. Replace filters, cleared condensate drain and washed outdoor units. Checked capacitors, electric motors and refrigerant circuit diagnostic. Disconnect/thermostats: good. No error code or notifications on CDA. All three systems are cooling the home at the time of maintenance.

Went over Warranty

Called client to go over issues. Client stated ecobee thermostat is set to 77 but reading 78 indoor and the unit not running. Advised on snowflake will be blue if unit is on. Advised on five minute compressor delay. Advised system can have a .5-1.5 temperature differential before kicking on. Recommend lowering compressor delay from 5 minutes to 2 minutes so system will maintain temperature at its set point. Will head out to take care of issue.

Performed a cooling maintenance on a Lennox condenser, condenser located on right side of home, filter located inside filter rack, fau located outside closet, changed 2 16x25 filter, check for thermostat, flushed condensation line, on condenser check for amperage and voltage, check for compressor, check for freon level, check for capacitors, check for disconnect box everything within range also clear out dust accumulated inside electrical component area and rinsed condenser coil. System is working within specification in cooling at the time of maintenance.

Performed a cooling maintenance on a 2020 American Standard package unit, changed 20x25 filter, filter located in ceiling, flushed condensation line, check for thermostat, on unit check for amperage and voltage, check for compressor, check for freon level, check for temperature split, checked for disconnect box, everything within range also clear out dust accumulated inside electrical component area and rinsed unit coil. System is working within specification in cooling at the time of maintenance.

Performed annual cooling maintenance on a 2024 American Standard Platinum unit and a 2017 Payne 3.5ton unit. Replaced 20x30, 20x20, and 14x14 filters. FAUs are located in hallway attic access. Cleared condensation lines from faus. Followed sequence of operations and checked voltage, condenser fan motor amps, compressor start/run amps, capacitor, hard start kit, temperature split, Freon levels, found no error codes on CDA for platinum unit, and rinsed condenser coils. Secured all electrical connections. Both thermostats checked out operational. Both systems are working properly in cooling at this time of service. Client renewed HFCP paid via CC.

Performed a cooling maintenance on a 2018 American Standard Platinum series condenser, condenser located on rooftop, filter located inside filter rack, fau located in garage, changed 20x22 filter, flushed condensation line, on condenser check for amperage and voltage, check for compressor, check for freon level, check if thermostat had no error codes or alerts, everything within range, check for disconnect box, clear out dust accumulated inside electrical component area and rinsed condenser coil. System is working within specification in cooling at the time of maintenance.