Coachella, CA

🛠️🛠️ On arrival, Client informed me that compressor was making a loud noise and system had stopped cooling Set thermostat to cool indoor blower kick on went to outdoor condenser for further investigation. Everything appeared to be working. With further investigation found weak run capacitor Also condenser fan motor starting to stick and making a humming noise on startup Spoke with client on findings recommend replacing condenser fan motor and capacitor Client approved ✅✅ System is cooling properly at this time

🛠️ Demand Service – System Operational Issue Upon arrival, client informed me that once the thermostat reached the desired temperature, the blower motor would continue running continuously until the thermostat was switched to the OFF position. Once switched off, the blower motor would shut down properly. Performed diagnostic testing by bypassing the thermostat and verifying system operation. Tested control board functionality and confirmed the circuit board was properly receiving and delivering 24 volts. Inspected thermostat wiring to ensure there were no shorts, crossed wires, or wiring making contact where it should not. After completing all testing procedures, it was determined that the thermostat was defective. Installed new thermostat and tested full system operation. System is now cycling on and off properly and operating within normal parameters. ✅ 📱 Unable to pair thermostat to client’s mobile device at this time due to client being unable to download the Resideo app.

Precision tuneup 2004 carrier split system Clear, condensation line Replaced customer supplied 4 inch filter located within the furnace/garage upflow. Cycle equipment followed, cooling sequence of operation checked refrigerant/ temperature split, checked capacitor, fan motor, compressor, amps and voltage Secured and clean electrical connections, at condenser and fuse box Thermostat checked out OK Rinse condenser coil and cleaned out leaves on the floor ✅ System is cooling at this time ⚠️ Equipment 22 years old Condenser fan motor is starting to leak oil and pulling high amps Contactor pitted and burnt due to age System is past desert life expectancy But still working

Upon arrival client stated system not cooling as well. Found system iced up to the compressor. Advised client we have to turn the system off till 6 tonight (7 hour defrost). Found really dirty filters. Advised client issue could just be the filter. After we turned the system off I found the condenser still running. Found contractor stuck closed due to dust. System is very dusty. Blew out dust from contactor and tested contactor multiple times. Advised client issue was most likely due to dirty filters and unit not turning off. Advised I will call at 6 to see if I will need to return. Advised on contactor replacement as well.

will use disposal

Quote for a separate 20 amp circuit in garage and take existing outlet make it double gang

🧊❄️ Performed a semi cooling service 2023 American Standard split heat/POV Replace 20 x 30 filter/seal mounted Cycle equipment follow cooling sequence of operation * checked capacitor * checked fan motor * checked compressor * checked refrigerant * checked amps and voltage * clear, condensation line * thermostat checked out OK * rinsed condenser coil ✅✅ Cooling equipment checked out operational at this visit

Performed a cooling maintenance on a 2013 XR split system unit. Check sequence of operations by checking out all electrical and refrigeration levels. At this time system is cooling down the house properly and within manufacturer specifications run capacitor rated for 45 was getting 45 at this time. Refrigeration levels are right on point tested out water pumps, and hallway closet as well as changed out filter. Explain the recommended a hard start kit to Client finish maintenance by washing down outdoor unit. same Client.

Today’s annual cooling preventative maintenance consisted of one TRANE package unit at first began with replacing the 20 x 30 filter in the home to ensure that proper airflow is able to circulate back to the system at minimal resistance. I then ensure that the thermostat is properly calling for cooling and turning the system on with no errors. All of the cooling sequence of operations are successfully checking out on the unit verifying there’s a proper 20° split and that the home is being called efficiently to the desired temperature. I ensure that the condensation line is in fact draining off the roof to the designated area properly. The capacitor for the blower motor are safely checking out in the correct range, verifying a controlled voltage is being used safely falling with the amps also safely testing out in the correct range as well. The coils on the unit can use a cleaning so that it can avoid additional buildup or debris on the coils on the inside of the unit as well as the blo

check both systems wash condenser clean condensation lines from attic check cooling and electrical components everything is working in cooling,,,,,casita mini split working properly,,,,,,garage mini split not cooling client started Essen ac company fix a refrigerant leak,,,,but unit is not cooling client will wait to see what he’s goi t to do

🧊❄️ 2014 R22 split system Preformed a semi annual cooling service Client replaces on filter And turned thermostat temperature down Follow cooling sequence of operation checked refrigerant, sub cool and super heat Cleared compensation line from outside. Checked capacitor, fan motor, compressor, amps and voltage Secured and clean electrical connections at condenser and fuse box Rinsed condenser coil ✅ Equipment is cooling at this time ⚠️ Spoke with client regarding starting apps and capacitor being out of range Per client sent an estimate for recommended repairs Attached does an estimate

Performed annual maintenance on a York rooftop package unit. Replaced 14” x 30” air filter; note that a screwdriver is required for filter access. Cleaned debris from return register. Verified sequence of operations and confirmed proper system performance with an average temperature split of 20°F. Inspected amperage draw and checked blower and condenser motors—operating within normal limits. Washed condenser coils. Cleared condensate drain line to ensure proper drainage. System is cooling effectively and operating properly at time of service.

Performed annual maintenance on a 2013 York rooftop package unit. Replaced 20” x 25” air filter and removed debris from return register. Conducted full operational check; system is functioning properly with an average temperature split of 20°F. Inspected blower and condenser motors—both operating within normal parameters. Cleared condensate drain line to ensure proper drainage. Washed condenser coil. System is operating efficiently at time of service.

HVAC options.

Performed annual maintenance in cooling on a American standard 5 ton , followed Sequence of operation Changed filter checked amps voltage capacitor pressures working at range cleared condensation rinsed condenser down unit is working to manufacture specification in cooling

Performed a cooling maintenance on 3 American standard split systems units. Check sequence of operations by checking out all electrical and refrigeration levels also cleaned out compensation lines with CO2 tank as well as cleaned out electrical compartment on condenser units at this time. All three units are cooling down the area properly reaching temperatures of 75° finish maintenance by changing out filters throughout building as well as by making sure thermostats are operating properly.

Performed annual AC maintenance on American standards POV split heat pump. Change 12 x 12 and 20 x 30 filters. Checked amps, volts, capacitor, and cleaned electrical compartment. Check, refrigerant levels, super heat, sub cool, and temperature split. Cleared line and clean coils. Also adjust fan speed due to home filling humid. found all electrical components in the refrigerant levels to be within manufactured specifications. System is operating and cooling properly at customer service.

Upon arrival, reset breaker but system would continue to trip breaker. Removed compressor from electrical circuit and system would operate without tripping the breaker. System has a grounded compressor. Emailed estimate for partial and complete system replacement.

The recent service involved the installation of a 4-ton A S Silver 14 SEER R410A condenser, alongside a new disconnect box. This work was completed following all necessary protocols to ensure optimal performance and compliance with industry standards. Please refer to this documentation for details regarding the services rendered. Need to send electrican to extend the high voltage for condenser

Returned to check isolation Condenser has a leak Will replace condenser, relocate and add new fuse box

Arrived to remove the existing ceiling fan and replace it with a customer-supplied ceiling fan. Upon arrival, the customer informed me that she wished to retain the current ceiling fan and that the issue was with her wall-mounted fan remote, which was malfunctioning. I tested the remote and confirmed it was not functioning properly. I provided continuous power to the ceiling fan to verify its operation but was not receiving power at the fan's circuit connection. I tested for electrical continuity and confirmed there was no continuity on either end of the circuit. Using a tone generator, I identified where the tones from both ends of the wiring circuit ended. I inquired if the customer had recently undergone any remodeling work; she noted that she had recently experienced water damage in her ceiling due to a damaged sprinkler. A repair company had cut into the drywall to fix the sprinkler in the area where the wiring tone terminated. Based on these observations, I concluded that the

Upon arrival client informed me system didn’t seem to be cool Set thermostat to cool with further investigation found system completely flat on refrigerant Performed isolation Will return after repairs are made for full system maintenance Provide provided two quotes for full system replacement

emailed quotes

Replace Lennox condenser coil under warranty. Replace filter drier and recharge system 9.5 pounds of r410a.

Performed annual heater maintenance on Goodman split gas system and Goodman split heat pump. Change 20 x 20 and 20 x 30 filters. Check amps, volts, capacitor and cleaned burner and electrical compartment. Checked gas and static pressures. Also check temperature rise and all safety switches .Cycled system from ecobee thermostat. Thermostat is operational. Checked refrigerant levels, super, subcool and temperature split.Recommend installing water safety switch and Jones valve. also recommend installing compressor savor kit for split heat pump. Emailed estimate for recommendation. Systems are operating at this time.